Refrigerator Repair in Port Moody

Refrigerator acting up? Tell us what's wrong, pick a time that works for you, and we'll connect you with a repair technician serving Port Moody — fast, easy, and no obligation.

Fridge not cooling?

Five checks that can fix the issue — no tools needed.

1. Check the temperature setting.

The dial can get nudged without you noticing. The fridge should be set near 3°C, the freezer near −18°C. If the setting was off, give the fridge a few hours to catch up.

2. Make sure the door actually closes.

Look for a shelf, drawer, or box holding the door open a crack. Check the rubber seal around the door — if it's cracked, loose, cold air may be leaking out.

3. Look for blocked vents inside.

Cold air moves through vents between the freezer and fridge. If they're obstructed by food, the cold can't circulate. Clear some space around the vents.

4. Clean the condenser coils.

Unplug the fridge first. The coils (black grille on the back, or behind the kick plate underneath) shed heat — a thick coat of dust makes the fridge run warm. Vacuum them gently.

5. Give it room, then give it a rest.

The fridge needs a couple of centimetres of breathing space on the sides and back. While it's unplugged from step 4, leave it off for ten minutes — a reset clears some electronic hiccups.

Still warm? Stop there. If none of that worked, the likely causes — compressor, refrigerant, fan motor, control board — aren't do-it-yourself territory. A closed fridge keeps food safe for about four hours, so there's time to do this right.

FAQ

Read the full guide: Fridge Not Cooling? 5 Quick Checks Before Booking a Repair

We arrange refrigerator repairs across Port Moody — including Samsung, LG, Whirlpool, GE, Bosch, Frigidaire, Maytag, KitchenAid, Miele, and other major brands.

All appliance repair in Port Moody · Freezer · Washer · Dryer · Dishwasher · Oven & Range · Microwave

This guide is general reference, not repair instructions. Unplug any appliance before touching more than its controls. Repairs beyond these checks should be done by a qualified technician.